RT2002-LP22 Roller Brake Tester

Single bed roller brake tester for passenger cars, vans and light commercial vehicles. Track = 2200 mm
FOR ON FLOOR and/or OUTDOOR INSTALLATION

The PERFECT solution to position ON FLOOR in front of a 4-post lift or on its own in combination with hot dip galvanised RAMPS.

ONLY 22cm HIGH

The RT2002-LP22 can also be installed OUTDOORS in combination with hot dip galvanised RAMPS and the L60-OD analogue/digital display.

In addition to measuring the brake forces per wheel and the difference between the left and right sides, the operator can determine the important quantities rolling resistance, actuation force, ovality (out-of-roundness) and brake fading for each wheel. Special attention has been given to prevent damage to the tires. The rollers are very quickly stopped when slippage occurs, even during the start-up of the motors. All roller brake testers are equipped with reliable worm gear motors. All moving components are supported by roller bearings for a long and trouble free service. The chassis is hot dip zinc.

Optional:
Cover plates (hot dip zinc)
Steel rollers
Set of ramps (L=2meter)(hot dip zinc)

Specifications:
Maximum axle load: 4 ton
Roller speed: 5 km/h
Brake force maximum: 8000 N
Rollers: 206 x 700 mm
Track: 800-2200 mm
Power supply: 2 x 5.5 kW; 3 phase, 400 V, 50 Hz
Dimensions: 284 x 66 x 22 cm
Chassis: hot dip zinc

Motor voltage and frequency other than 3 phase 400 V / 50Hz are available upon request.


RT2002-LP22 + ramps


RT2002-LP22 + ramps


With ramps and 4-post lift


L60-OD analogue/digital display for OUTDOORS

Make a choice

Categories
- Cars
- Commercial vehicles
- Caravans & Trailers

Product Groups
- Consoles for roller testers
- Pedal force meters
- Plate brake testers
- Play detectors
- Roller brake testers
- Roller tester add-ons
- Sideslip meters
- Speedometers
- Suspension testers

Disclaimer | Copyright © 2018 Altus-Escon-Company BV, Inc. All Rights Reserved